Simple numeric display of milk yield (litres), milking time (minutes:seconds) and highest conductivity (mS – millisiemens)
24 keys – full keypad for animal number entry (alphanumeric), automatic milking, manual milking, wash, gate controls, quick sort, left, right and warning flags
Simple, bright 2 x 20 LCD display
3 graphical LED windows for expected milk yield (MY), expected conductivity (MC) and expected milking time (MT) – requires Micro M5 control
8 LED windows for auto milking, pulsation, ACR, milk flow, conductivity milking, retention bar, data and dump line
2 automatic milking modes – 1 time-based cluster removal and 1 sensor-based cluster removal
3 manual milking modes (ACR disabled, conductivity pull off disabled, ACR and conductivity disabled)
Accurate milk yield measurement (± 5%).
Accurate milk flow measurement for ACR removal.
Full pulsation control – 30 to 180 pulses per minute (ppm) and 35% to 75% ratios including pulsation stop – pulsator only on when milking or washing.
Washing pulsation – runs pulsation frequency at lower rate during washing to reduce liner wear
User programmable wash time.
Wash time elapsed and remaining displayed (minutes:seconds).
User set conductivity warning and pull off levels
User selectable ACR pull off milk flow and time.
Lift to start ACR input / swing to start input.
Automatic idle after user selectable period of inactivity.
Milk sweep / purge.
Small form factor, allowing for easy installation into existing parlours.
Suitable for all herd / flock sizes of cows, sheep and goats.
Suitable for abreast, tandem, herringbone, parallel or rotary parlours.
Ability to lower clusters below the bridge on rotary parlours.
Total litres of milk measured per milking for each milk meter can be displayed and added together to easily check calibration.
M2 communications bus – enables all MM80 controls to be put into milk or wash from MM Hub and animal data to be sent / received from Micro M5
Warning flags can be set and acknowledged against each animal using the flag key
If using time-based cluster removal can change the milking time for all points from 1 control
Top up feed (TuF) allows operator to top up feed from the milk meter control.
Dump line changeover
Suitable for cows, sheep and goats
Suitable for high or low level parlours
Graphical display via LED windows of expected milk yield (MY), expected conductivity (MC) and milking time (MT) – each window flashes red if expected values not met during milking for easy diagnosis of problems by the operator