aUTOMATIONS

MM10 Milk Meter

The MM10 milk meter is an entry level system with milk yield measurement (± 5%) and milking time. It connects to the Micro M5 parlour control and Cowculator M5 PC software.

Control Features
Simple numeric display of milk yield (litres) and milking time (minutes:seconds).
3 keys – automatic milking, manual milking, and wash.
Simple, bright OLED display
2 automatic milking modes – 1 time-based cluster removal and 1 sensor-based cluster removal.
Accurate milk yield measurement (± 5%).
Accurate milk flow measurement for ACR removal.
User programmable wash time.
Wash time elapsed and remaining displayed (minutes:seconds).
User selectable ACR pull off milk flow and time.
Lift to start ACR input / swing to start input.
Automatic idle after user selectable period of inactivity.
Milk sweep / purge.
Small form factor, allowing for easy installation into existing parlours.
Suitable for all herd / flock sizes of cows, sheep and goats.
Suitable for abreast, tandem, herringbone, parallel or rotary parlours.
Ability to lower clusters below the bridge on rotary parlours.
Total litres of milk measured per milking for each milk meter can be displayed and added together to easily check calibration.
Integration Features
These features are available if the MM10 controls are connected to the Micro M5 parlour control system.
M2 communications bus link to ATL system – includes activation of LED signalling bus functioning in bottom left of MM10 control.
Conductivity measurement of milk (millisiemens).
Sending of animal numbers and warning flags to MM10 control – operator can only acknowledge warnings – they cannot set them on the MM10 control – to do this they have to use the Micro M5 parlour control.
Sending of milk yield, milking time and conductivity information to Micro M5.
Flask Features
Manufactured from polysulfone for excellent mechanical strength and chemical and temperature resistance.
Dumping milk meter – plunger on diaphragm lift to open outlet and empty milk when milk reaches top probe. It then falls to close outlet and enable flask to fill with milk again.
Each dump is approximately 200ml.
Milk Inlet – 15mm ID, 19mm OD.
Milk Outlet – 18mm ID, 22mm OD.
No electronic parts with milk meter – simple design ensures low service costs.

Want to learn more?

Download the product PDF Leaflet here

DOWNLOAD

Download the product PDF Manual here

DOWNLOAD

Not found what you're looking for?