aUTOMATIONS

MM35 Milk Meter

The MM35 milk meter includes milk yield measurement (± 5%), conductivity measurement, milking time, health attentions and top up feed button. It has been designed for swingover and multi-point (where one milking unit is sued on 2 or 3 animal standings) parlours. It connects to the Micro M5 parlour control and Cowculator M5 PC software.

Control Features
Simple numeric display of milk yield (litres), milking time (minutes:seconds) and highest conductivity (mS – millisiemens).
6 keys – automatic milking, manual milking, wash, conductivity on/off, top up feed and warning flags.
Simple, bright OLED display
7 LED windows for auto milking, pulsation, ACR, milk flow, conductivity milking, data and dump line.
2 windows with multiple LEDs graphically displaying conductivity level.
2 automatic milking modes – 1 time-based cluster removal and 1 sensor-based cluster removal.
3 manual milking modes (ACR disabled, conductivity pull off disabled, ACR and conductivity disabled).
Accurate milk yield measurement (± 5%).
Accurate milk flow measurement for ACR removal.
Full pulsation control – 30 to 180 pulses per minute (ppm) and 35% to 75% ratios including pulsation stop – pulsator only on when milking or washing.
Stimulation pulsation.
Washing pulsation – runs pulsation frequency at lower rate during washing to reduce liner wear.
User programmable wash time.
Wash time elapsed and remaining displayed (minutes:seconds).
User set conductivity warning and pull off levels
User selectable ACR pull off milk flow and time.
Lift to start ACR input / swing to start input.
Automatic idle after user selectable period of inactivity.
Milk sweep / purge.
Small form factor, allowing for easy installation into existing parlours.
Suitable for all herd / flock sizes of cows, sheep and goats.
Suitable for abreast, tandem, herringbone, parallel or rotary parlours.
Ability to lower clusters below the bridge on rotary parlours.
Total litres of milk measured per milking for each milk meter can be displayed and added together to easily check calibration.
M2 communications bus – enables all MM35 controls to be put into milk or wash from 1 control and animal data to be sent / received from Micro M5
Warning flags can be set and acknowledged against each animal using the flag key
If using time-based cluster removal can change the milking time for all points from 1 control
Top up feed (TuF) allows operator to top up feed from the milk meter control.
Dump line changeover
Suitable for cows, sheep and goats
Suitable for high or low level parlours
Flask Features
Manufactured from polysulfone for excellent mechanical strength and chemical and temperature resistance.
Dumping milk meter – plunger on diaphragm lift to open outlet and empty milk when milk reaches top probe. It then falls to close outlet and enable flask to fill with milk again.
Each dump is approximately 200ml.
Milk Inlet – 15mm ID, 19mm OD.
Milk Outlet – 18mm ID, 22mm OD.
No electronic parts with milk meter – simple design ensures low service costs.

Want to learn more?

Download the product PDF Leaflet here

DOWNLOAD

Download the product PDF Manual here

DOWNLOAD

Not found what you're looking for?