MM10 Milk Meter
The MM10 milk meter is a simple and accurate, non-approved milk meter. It can be used stand-alone or integrated into the ATL system.


MM10 Milk Meter
The MM10 milk meter is an entry level system with milk yield measurement (± 5%) and milking time. It connects to the Micro M5 parlour control and Cowculator M5 PC software.
Control Features
- Simple numeric display of milk yield (litres) and milking time (minutes:seconds)
- 3 keys – automatic milking, manual milking, and wash
- Simple, bright graphical LCD display
- 2 automatic milking modes – 1 time-based cluster removal and 1 sensor-based cluster removal
- Accurate milk yield measurement (± 5%)
- Accurate milk flow measurement for ACR removal
- User programmable wash time
- Wash time elpased and remaining displayed (minutes:seconds)
- User selectable ACR pull off milk flow and time
- Lift to start ACR input / swing to start input
- Automatic idle after user selectable period of inactivity
- Milk sweep / purge
- Small form factor, allowing for easy installation into existing parlours
- Suitable for all herd / flock sizes of cows, sheep and goats
- Suitable for abreast, tandem, herringbone, parallel or rotary parlours
- Ability to lower clusters below the bridge on rotary parlours
- Total litres of milk measured per milking for each milk meter can be displayed and added together to easily check calibration
Integration Features
- These features are available if the MM10 controls are connected to the Micro M5 parlour control system
- M2 communications bus link to ATL system – includes activation of LED signalling bus functioning in bottom left of MM10 control
- Conductivity measurement of milk (millisiemens)
- Sending of animal numbers and warning flags to MM10 control – operator can only acknowledge warnings – they cannot set them on the MM10 control – to do this they have to use the Micro M5 parlour control
- Sending of milk yield, milking time and conductivity information to Micro M5
Flask Features
- Manufactured from polysulfone for excellent mechanical strength and chemical and temperature resistance
- Dumping milk meter – plunger on diaphragm lift to open outlet and empty milk when milk reaches top probe. It then falls to close outlet and enable flask to fill with milk again
- Each dump is approximately 200ml
- Milk Inlet – 15mm ID, 19mm OD
- Milk Outlet – 18mm ID, 22mm OD
- No electronic parts with milk meter – simple design ensures low service costs