CR35 Cluster Remover

The CR35 cluster remover is one of the most useful additions to a milking parlour.

The CR35 cluster remover includes flow and time-based removal, along with conductivity measurement, pulsation control and is upgradeable into a milk meter.

They can be used on cow, goat and sheep parlours.

cr35-control-large-2 cr35-control-large-1

CR35 Cluster Remover

The CR35 cluster remover includes flow and time-based removal, along with conductivity measurement, pulsation control, data connection to allow communication with each other and the Micro M5, and are upgradeable to milk meters.

Control Features:

  • Simple numeric display of milking time (minutes:seconds) and conductivity (mS – millisiemens)
  • 6 keys – automatic milking, manual milking, wash, conductivity on/off, left and right
  • Simple, bright LCD display
  • 7 LED windows for auto milking, pulsation, ACR, milk flow, conductivity milking, data and dump line
  • 2 automatic milking modes – 1 time-based cluster removal and 1 sensor-based cluster removal
  • 3 manual milking modes (ACR disabled, conductivity pull off disabled, ACR and conductivity disabled)
  • Time-based cluster removal does not require a sensor
  • Accurate milk flow measurement for ACR timing
  • Full pulsation control – 30 to 180 pulses per minute (ppm) and 35% to 75% ratios
  • Pulsation stop – pulsator only on when milking or washing
  • Stimulation pulsation
  • Washing pulsation – ability to run pulsation frequency at lower rate during washing to reduce liner wear
  • User programmable wash time
  • Wash time elapsed and remaining displayed (minutes:seconds)
  • User selectable conductivity warning and pull off levels
  • User selectable ACR pull off resistance and time
  • Lift to start ACR cylinder input
  • M2 communications bus – enables all CR35 controls to be put into milk or wash from 1 control
  • Automatic idle after user selectable period of inactivity
  • Milk sweep / purge
  • Small form factor, allowing for easy installation into existing parlours
  • Suitable for all herd sizes (small or large)
  • Can be retrofitted into abreast, herringbone or rotary parlours

Upgrade Features:

  • These features are available if the CR35 controls are upgraded to connect to the Micro M5 parlour control system
  • Sending animal numbers and warning flags to CR35 control
  • Sending of milking time and conductivity to Micro M5
  • Upgradeable to milk meter by adding milk meter flask

Sensor Features:

  • Free-flowing sensor incorporating shut-off valve
  • The tangential entry and the wide discharge tube allow smooth passage and evacuation of high milk flows
  • The sensor shape reduces vacuum fluctuations
  • The diaphragm shape is designed to prevent accidental closure and allow rapid response, facilitating instant detachment of the milking unit
  • Swirl effect on inside surfaces of sensor induces effective washing
  • The vacuum nipple can be positioned in any direction
  • Milk inlet and outlet nipples – 21mm x 16mm